drm/nouveau/nvkm: clear use.enabled when subdev init fails
Default status is the baseline for the product, each version can override it (e.g. patched versions marked unaffected).
| Vendor | Product | Default status | Versions | |||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Linux | Linux | unaffected |
|
|||||||||||||||||||||
| Linux | Linux | affected |
|
No data.
No data.
No data available yet.
No CVSS v4.0
No CVSS v3.1
No CVSS v3.0
No CVSS v2
This CVE is not in the KEV list.
No EPSS score available.
Key SSVC decision points have not yet been added.
| Type | Values Removed | Values Added |
|---|---|---|
| Description | In the Linux kernel, the following vulnerability has been resolved: drm/nouveau/nvkm: clear use.enabled when subdev init fails On Kepler boards without the video decode falcon firmware installed (msvld/mspdec/msppp), every other VA-API decode attempt binds to an engine with no ucode loaded. The submitted work never completes, which leads to a context switch timeout, a channel recovery that cannot reset the engine, and eviction waits on fences that never signal. The process ends up stuck in D state, or killed by SIGBUS when it touches a buffer evicted after the wait times out: msvld: unable to load firmware data msvld: init failed, -19 fifo: SCHED_ERROR 0a [CTXSW_TIMEOUT] vo[5444]: channel 14 killed! WARNING: drivers/gpu/drm/nouveau/nvkm/engine/fifo/runl.c:117 at nvkm_runl_rc+0x2a4/0x3b0 [nouveau] [TTM] Buffer eviction failed WARNING: drivers/gpu/drm/nouveau/nouveau_bo.c:1092 at nouveau_bo_move_ntfy.part.0+0x9b/0x100 [nouveau] Tracing nvkm_subdev_ref() and nvkm_subdev_init_() shows the pattern: a reference taken with enabled=0 runs nvkm_falcon_init(), which returns -ENODEV; the next reference sees enabled=1 and succeeds without running it. Clear use.enabled when init() fails, so that every later reference retries init and fails cleanly. The other readers of use.enabled are fini() handlers that use it to skip teardown, which they now also do after a failed init(). On a GK107 (Quadro K1100M) without video firmware, playing H.264 with mpv --hwdec=auto: without this patch the GPU channel is killed within a minute and mpv hangs; with it, VA-API decoder creation fails, mpv falls back to software decoding, and no faults are logged. | |
| Title | drm/nouveau/nvkm: clear use.enabled when subdev init fails | |
| First Time appeared |
Linux
Linux linux Kernel |
|
| CPEs | cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:* | |
| Vendors & Products |
Linux
Linux linux Kernel |
|
| References |
|
No weakness.