Search vulnerabilities

Results 16,558

Export CSV
CVE-2026-64504

iio: accel: bmc150: clamp the device-reported FIFO frame count

In the Linux kernel, the following vulnerability has been resolved: iio: accel: bmc150: clamp the device-reported FIFO frame count __bmc150_accel_fifo_flush() copies the number of samples the device reports in its hardware FIFO into an on-stack buffer u16 buffer[BMC150_ACCEL_FIFO_LENGTH * 3]; which is sized for at most BMC150_ACCEL_FIFO_LENGTH (32) samples. The frame count is read from the FIFO_STATUS register and only masked to its 7 valid bits: count = val & 0x7F; so it can be 0..127. The only other limit applied to it is the optional caller-supplied sample budget: if (samples && count > samples) count = samples; which does not constrain count on the flush-all path (samples == 0), and leaves it well above 32 whenever samples is larger. count samples are then transferred into buffer[]: bmc150_accel_fifo_transfer(data, (u8 *)buffer, count); bmc150_accel_fifo_transfer() reads count * 6 bytes through regmap, so a malfunctioning, malicious or counterfeit accelerometer (or an attacker tampering with the I2C/SPI bus) that reports up to 127 frames writes up to 762 bytes into the 192-byte buffer: a stack out-of-bounds write of up to 570 bytes that clobbers the stack canary, saved registers and the return address. Clamp count to BMC150_ACCEL_FIFO_LENGTH, the number of samples buffer[] is sized for, before the transfer, mirroring the watermark clamp already done in bmc150_accel_set_watermark(). A well-formed flush reports at most BMC150_ACCEL_FIFO_LENGTH frames, so legitimate devices are unaffected.

CVSS 3.1 · 5.5 Medium EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-90591

NXP ENET-QOS Ethernet driver re-arms RX descriptors with a clobbered DMA buffer address on packet drop

The NXP ENET-QOS Ethernet driver's receive work handler eth_nxp_enet_qos_rx() in drivers/ethernet/eth_nxp_enet_qos hands each processed descriptor back to the DMA by writing desc->read.control = rx_desc_refresh_flags, which sets OWN_FLAG and BUF1_ADDR_VALID_FLAG. RDES0 of a receive descriptor is the DMA buffer address in read format, but the hardware write-back aliases that word with the VLAN tag fields (or, for a context descriptor, the timestamp low word), so it is destroyed on every completion. The success path rewrites desc->read.buf1_addr before re-arming; the four drop paths — errored or non-first descriptor, net_pkt_rx_alloc() failure, invalid descriptor length, and net_pkt_get_frag() failure — did not, re-arming the ring slot with the write-back residue as its DMA target address. The drop paths are driven entirely by received traffic and need no privilege or special configuration. With the defaults for this driver (CONFIG_NET_BUF_DATA_SIZE of 128 and 16 receive descriptors) a single full-size frame consumes twelve ring slots and twelve K_NO_WAIT fragment allocations, so a short burst of frames sent to the device exhausts the receive pools and reaches the allocation-failure paths; a frame with a receive error, or any frame whose first descriptor was already dropped, reaches the non-first-descriptor path. Once a slot has been poisoned, the DMA writes the next frame received in that slot to an address derived from the frame's VLAN tag fields rather than to a receive buffer. On the supported MCX SoCs that address falls in flash or reserved space, so the transfer raises a fatal bus error that the driver only logs — there is no reset or recovery path — and reception stops permanently until the device is rebooted; where the write is silently discarded instead, the untouched buffer is later handed to the network stack with a length, delivering stale buffer contents as if they were a received frame. A single triggering event is enough to make the condition persistent, so an attacker able to send traffic to the device can permanently disable its network interface.

CVSS 3.1 · 7.5 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-76970

Memory Corruption vulnerability in Application Server ABAP for SAP NetWeaver and ABAP Platform

Due to a Memory Corruption vulnerability in Application Server ABAP for SAP NetWeaver and ABAP Platform, an unauthenticated attacker could send specially crafted requests to the application. If processed by the application, these requests could trigger a memory corruption condition in the parsing routine, which could cause the affected processes to crash and restart. By repeatedly sending such requests, the attacker could cause a sustained denial of service, leading to a high impact on availability. Confidentiality and integrity remain unaffected.

CVSS 3.1 · 7.5 High EPSS < 1% KEV · Not listed
Vendors
CVE-2026-68589

In Modem, there is a possible out of bounds write due to a missing bounds check. This could lead to local escalation of privilege if a malicious actor has already obtained the System privilege. User interaction is not needed for exploitation. Patch ID: MOLY01320076; Issue ID: MSV-6889.

CVSS 3.1 · 6.7 Medium EPSS < 1% KEV · Not listed
Products
CVE-2026-20584

In usb, there is a possible memory corruption due to a missing bounds check. This could lead to local escalation of privilege if a malicious actor has already obtained the System privilege. User interaction is not needed for exploitation. Patch ID: ALPS11411916; Issue ID: MSV-9746.

CVSS 3.1 · 6.7 Medium EPSS < 1% KEV · Not listed
Products
CVE-2026-20585

In Modem, there is a possible out of bounds write due to a missing bounds check. This could lead to remote escalation of privilege, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01338165; Issue ID: MSV-9660.

CVSS 3.1 · 7.5 High EPSS < 1% KEV · Not listed
Products
CVE-2026-63838

ASoC: rsnd: Fix potential out-of-bounds access of component_dais[]

In the Linux kernel, the following vulnerability has been resolved: ASoC: rsnd: Fix potential out-of-bounds access of component_dais[] component_dais[RSND_MAX_COMPONENT] is initially zero-initialized and later populated in rsnd_dai_of_node(). However, the existing boundary check: if (i >= RSND_MAX_COMPONENT) does not guarantee that the last valid element remains zero. As a result, the loop can rely on component_dais[RSND_MAX_COMPONENT] being zero, which may lead to an out-of-bounds access. Found by Linux Verification Center (linuxtesting.org) with SVACE.

CVSS 3.1 · 7.1 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-63896

usb: gadget: composite: fix integer underflow in WebUSB GET_URL handling

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: composite: fix integer underflow in WebUSB GET_URL handling The WebUSB GET_URL handler in composite_setup() narrows landing_page_length to fit the host-supplied wLength using landing_page_length = w_length - WEBUSB_URL_DESCRIPTOR_HEADER_LENGTH + landing_page_offset; If wLength is smaller than WEBUSB_URL_DESCRIPTOR_HEADER_LENGTH the unsigned subtraction wraps, and the subsequent memcpy(url_descriptor->URL, cdev->landing_page + landing_page_offset, landing_page_length - landing_page_offset); ends up copying close to UINT_MAX bytes from cdev->landing_page into cdev->req->buf. KASAN reports a slab-out-of-bounds in composite_setup on the kmalloc-2k gadget_info allocation, and FORTIFY_SOURCE traps the memcpy as a 4294967293-byte field-spanning write into url_descriptor->URL (size 252). A USB host can reach this from a single SETUP packet against any gadget that has webusb/use=1 and a landingPage configured. Handle the small-wLength case before the math: when the host requested fewer bytes than the URL descriptor header, only the header is meaningful and no URL bytes need to be copied. Setting landing_page_length to landing_page_offset makes the existing memcpy a no-op and leaves the descriptor returned to the host unchanged for all larger wLength values.

CVSS 3.1 · 5.5 Medium EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-100229

gstreamer1-plugins-bad-free: gstreamer1-plugins-bad-free: out-of-bounds write in gst_h266_parser_parse_dci() due to off-by-one array bound check

No standard GStreamer pipeline element invokes the vulnerable parser API. Exploitation would require a third-party application to call it with attacker-controlled H.266 DCI data.

CVSS 3.1 · 6.5 Medium EPSS n/a KEV · Not listed
Vendors
CVE-2026-119958

Windows LDAP - Lightweight Directory Access Protocol Remote Code Execution Vulnerability

Out-of-bounds write in Windows LDAP - Lightweight Directory Access Protocol allows an unauthorized attacker to execute code over a network.

CVSS 3.1 · 9.8 Critical EPSS 1.3% KEV · Not listed
Vendors
CVE-2026-113516

After Effects | Out-of-bounds Write (CWE-787)

After Effects is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-113530

After Effects | Out-of-bounds Write (CWE-787)

After Effects is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-113541

Media Encoder | Out-of-bounds Write (CWE-787)

Media Encoder is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-110086

Premiere Pro | Out-of-bounds Write (CWE-787)

Premiere Pro is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-110085

Premiere Pro | Out-of-bounds Write (CWE-787)

Premiere Pro is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-117547

Photoshop Desktop | Out-of-bounds Write (CWE-787)

Photoshop Desktop is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-113517

After Effects | Out-of-bounds Write (CWE-787)

After Effects is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-113525

After Effects | Out-of-bounds Write (CWE-787)

After Effects is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products
CVE-2026-116003

Photoshop Desktop | Out-of-bounds Write (CWE-787)

Photoshop Desktop is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file.

CVSS 3.1 · 7.8 High EPSS < 1% KEV · Not listed
Vendors
Products